Do not limit yourself to be smart

Wooden Vanity Units

How To Install Solid Wooden Vanity Units

A set of wooden vanity units is a great way to make a small bathroom feel more luxurious and give it some much-needed storage. Also, if you don’t have the tools or time to install them yourself, plenty of convenient services can help you with the installation process. With the help of this article and our handy tips, installing your own Solid Wooden Vanity units can be easy.


A solid wooden vanity unit is a valuable asset in your bathroom, and if you want these to last, you’ll want to take some time when installing one. It’s easy with the help of this article, so get started by reading on!


You’ll need a few things to install a new solid wooden unit yourself. You will need wood glue, which can be found in most hardware stores. For screws, it would be best if they were already pre-drilled holes, as they’re easier to install than ones that are just pencil-sized. Last but not least, you’ll need lumber clamps or a metal clamp tool that is strong enough to hold up the weight of the vanity unit without breaking or scratching it.

Wooden Vanity Units

 You can install the screws and glue them into the wood using a screwdriver, or you can use pre-drilled holes. You can also use a drill to make them. However, if you choose this option, make sure that it is long enough so that it doesn’t hit the vanity unit’s legs, as this will damage them.


It would also be best to measure so that all of the measurements are accurate and proper, meaning your vanity unit fits into place properly. You’ll also need to consider where you’d like your drain to be when installing. A significant consideration when installing any sink will be ensuring that it is not by another drain. This can be quite a pain to unclog.


Finally, before installing your vanity, removing any old unit is essential. Begin by removing the screws holding onto your old unit. Carefully remove these screws from the legs of the unit and then lift them a little bit at a time.


Since you’ll want to leave a small gap for water damage repair, you’ll need to consider this when placing your new unit where you want it. It’s best if you measure out the area so that it will fit into place properly before starting gluing and screwing in your new vanity unit.